How to Replace a Design Bar in your Bijoulee Ring

Step 1: Holding the Bijoulee Ring

Hold the Bijoulee Ring base between your thumb and index fingers.

Hold the Design Bar in your other hand between your thumb and index fingers.

Step 2: Inserting the Design Bar

Insert the Design Bar into the two grooves in the Bijoulee Base Ring simultaneously.

Step 3: Tightening the Design Bar

Move the Design Bar simultaneously between the two grooves until it reaches the end of the grooves.

Step 4: Sliding the Ring onto your Finger

Continue holding the assembled ring from the two ends of the Design Bar, between your thumb and index fingers, and slide the ring on your finger.

If you find it hard to pass the knuckle, try turning the ring at a 45-90 degrees angle before the knuckle, pass the knuckle, and then turn it back with the design facing upward.